REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the windscreen pillar trim (see Windscreen pillar
trim: Removal - Refitting) (71A, Body internal
trim),
- the interior rear-view mirror (see 57A, Interior
equipment, Interior rear-view mirror: Removal -
Refitting, page 57A-18) (57A, Interior equipment),
- the windscreen wiper arms (see Windscreen wiper
arm: Removal - Refitting) (85A, Wiping -
Washing),
- the scuttle panel grille (see Scuttle panel grille:
Removal - Refitting) (56A, Exterior equipment).
- Remove the windscreen trim (1) .
- Fit the universal protector (Car. 1847).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
- Protect the windscreen perimeter using masking
tape (2) .
- Begin cutting the cement bead.
REFITTING
I - REFITTING PREPARATIONS OPERATION
- Position the two side positioning shims.
- Refit the rubber stop.
- For the preparation and the bonding (see Window
bonding: Description) (Technical Note 560A, 54A,
Windows).
II - REFITTING OPERATION FOR PART
CONCERNED
Note:
Always use high modulus adhesive to bond the
rear window. |
- Refit the windscreen (this operation requires two
people).
- Respect the following clearances and shut lines:
- windscreen - roof,
- windscreen - A-pillar.
III - FINAL OPERATION.
- Clip the trim piece in place (3) .
- Refit:
- the scuttle panel grille (see Scuttle panel grille:
Removal - Refitting) (56A, Exterior equipment),
- the windscreen wiper arms (see Windscreen wiper
arm: Removal - Refitting) (85A, Wiping -
Washing),
- the interior rear-view mirror (see 57A, Interior
equipment, Interior rear-view mirror: Removal -
Refitting, page 57A-18) (57A, Interior equipment),
- the windscreen pillar trim (see Windscreen pillar
trim: Removal - Refitting) (71A, Body internal
trim).
|