Renault Koleos Service Repair Manual: Pressure sensor: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Remove the front bumper (see Front bumper: Removal - Refitting) (55A, Exterior protection).
• Drain the refrigerant circuit using the refrigerant charging station (see 62A, Air conditioning, Coolant circuit Draining - Refilling, page 62A-11) .

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Disconnect the connector (1) .
• Remove the pressure sensor (2) .

REFITTING

I - REFITTING PREPARATION OPERATION

• Always replace the seal (3) .

II - REFITTING OPERATION FOR PART CONCERNED

• Refit the pressure sensor.
• Torque tighten the pressure sensor nut (11 N.m).
• Connect the connector (1) .

III - FINAL OPERATION.

• Refit the front bumper (see Front bumper: Removal - Refitting) (55A, Exterior protection).
• Fill the refrigerant circuit using the refrigerant charging station (see 62A, Air conditioning, Coolant circuit Draining - Refilling, page 62A-11) .
• Set the control of the passenger compartment blower unit to the maximum speed.
• Check that the air conditioning system is operating correctly (see 62A, Air conditioning, Air conditioning: Check, page 62A-6) .
• Check for leaks (see 62A, Air conditioning, Coolant circuit check, page 62A-9) .