Useful capacity of fuel tank:
To open the cover A, pull the control 1. Use the cap holder 3 on the flap A during filling to hold the cap 2 in place.
Fuel grade Use a high-grade fuel that complies with the legislation in force in each country and which must comply with the specifications given on the label on the cover A. Petrol version It is essential to use unleaded petrol. The octane rating (RON) must comply with the information given on the label on the cover A. Diesel version Only use diesel fuel which complies with the information on the label located inside the cover A.
Filling with fuel With the ignition off, insert the nozzle and insert it fully before turning it on to fill the fuel tank (risk of splashing). Keep the nozzle in this position throughout the entire filling operation. When the pump cuts out automatically at the end of the filling procedure, a maximum of two further filling attempts may be made, as there must be sufficient space in the fuel tank to allow for expansion. Make sure that no water enters the fuel tank during filling. The cover A and its surround must remain clean. Petrol versions Using diesel fuel will damage the antipollution system and may lead to a loss of warranty. To ensure that the fuel tank is not filled with diesel fuel, the fuel tank filler neck consists of a restrictor fitted with a safety system which only allows a nozzle for petrol to be used (at the pump).
Running out of fuel on diesel versions Vehicles with key/remote control
Vehicles with RENAULT card With the card RENAULT in the passenger compartment, press the start button 4 without pressing any of the pedals. Wait a few minutes before starting. This will enable the fuel circuit to be primed. If the engine does not start, repeat the procedure. If the engine does not start after several attempts, please contact an authorised dealer.
|
Renault Koleos Service Repair Manual > Front axle components: Front brake hose: Removal -
Refitting
WARNING Prepare for the flow of fluid, and protect the surrounding components. REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment). Set the wheels straight ahead. Remove the front wheel (see 35A, Wheels and tyr ...